How much RPM in Turbocharger in Diesel engine.
- 9 Answers
- 43758 Views
- Greaves, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / mahesh bial airport
10000 RPM to 130000 RPM In case below this rpm copressed
air mass is less & required firepoint is not reach the fuel
then flash point is not creat and not working the equipment
| Is This Answer Correct ? | 25 Yes | 18 No |
Post New Answer View All Answers
What is the need for a controller?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
Can u tell me design of switch yard
hi friends if you have any 400KV Substation Erection and installations Drgs please send to me.My email id:kandi.suresh441@gmail.com
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
What is CCT (Correlated Color Temperature) ?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What is the necessary condition for stability.
In parallel operation time both NGR’s close or not close if both close what will happen
Where servomechanism is used?
