1.What is the difference between Diplexer and Duplexer and
what position?
2. What is the different between CDU C and CDU A
3. How do you link a T1 from the 1st BTS to 2nd BTS
4. What is the value for TEI 1st T1?
5. What is the SSI?
Answer Posted / sahani.santosh@gmail.com
1.diplexer is used if we want to use same antenna line[feeder] for two different type of waves.like using same feeder for gsm n cdma transmission to gsm..even if to physically separateed antennas are there only a set of feeder will be required DUPLEXER is used if we want same antenna to transmit n receive..instead of using two separate ones..
3.There r so many ways o transfering E1/t1 FROM ONE BTS TO ANOTHER..used twisted pair cable w E1T1 card or RRI w in use but power off ..so many ways..
4.SS7 is the protocol used for transmissin of non voice dats transfer[signalling ],that r used for call setup etc
Is This Answer Correct ? | 16 Yes | 4 No |
Post New Answer View All Answers
Explain fdd in gsm technology?
What is the difference between rx lev sub and rx lev full? What you mean by link budget?
What is imsi in gsm technology?
What do you mean by link budget?
Explain tdd?
Explain the cycling frequency hopping in gsm technology?
What do you mean by extended cell?
What is the maximum data rate supported by a gsm system?
Explain tmsi?
What is drx in gsm technology?
Explain imei?
Explain hsn?
Explain cycling frequency hopping?
what is equalisation in gsm technology
What is the difference between cdu c and cdu a?