1.Can anybody explain Why starters are not used for motor
starting in industries?
2.
- 7 Answers
- 6665 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh
In industries they normally use it.Ofcourse it may not be
required for motor of lower ratting say below 1kW or around
it.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
What is rotary phase converter?
What is transient response?
why asa method ZPF method is more accurate than ASA method?
What are the disadvantages of autotransformer?
What are the advantage of free wheeling diode in a full wave rectifier?
what will happen if there is a voltage leakage or current leakage in an electrical train
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
i need mat lab program to find out the transmission line losses,regulation and losses
what mean by analog ,digital,numerical meters and relays? say the example?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
What is electrical grounding?
