1.Can anybody explain Why starters are not used for motor
starting in industries?
2.
- 7 Answers
- 6666 Views
- I also Faced
- E-Mail Answers
Answer Posted / sennapparajan
i dont think. In all places ,motors are used to start by
starters only.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
what is the difference between megger and earth resister ??
Is MEN and RCD related to each other ?? IF yes then how??
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
Direction of flow of active power and reactive power with logic?
why sielent pole is used only in hydro generators and not in turbo generators
how to measure earth resistance of a substation
How will be the single line diagram of series trip HT breaker? how it works?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
is it possible to test of bus bar in high rise building without completed full floor ?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
Sir, I have applied for the of Jr.engineer(Electrical & Electronics) & ASST. LOCO PILOT at ALL RRB BOARDS. please send me all RRB Boards solved papers in the year of 2001 tO till date. i requested send me the papers to my id as soon as possible (jet_0991@yahoo.com). (This is very urgent) Thank You,
What is A check, B check, C Check & D check for a diesel Generat
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
