Interested to Buy Any Domain ? << Click Here >> for more details...
Why is making current of CB always greater than CB breaking burrent?.
- 6 Answers
- 27019 Views
- JP Group, I also Faced
- E-Mail Answers
Answer Posted / palani
The CB breaking current is less than Making current. The
breaking occur at the zero of the alternating Current where
as making occur at any amplitude of current in the
alternating current .
| Is This Answer Correct ? | 20 Yes | 18 No |
Post New Answer View All Answers
What are the uses of lead compensator?
a starter used for squirrel cage induction motor?
Why LED light has advantage of rapid reflection ,although other lights alse reflect.? and this light is considered to be best for transmission usage in case of Free optics
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
if sf6 gas low in gis what will happen
primery try cell?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
Write down the design procedure of commutaj.
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
why are the maintaine power factor and how can this control and this is how work.
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
why we use circuit breakers for switching instead of normal switching device?
