What is the IP address of the switch?
Answer Posted / dikshit
The switch can obtain its IP configuration automatically
using one of the following protocols:
Bootstrap Protocol (BOOTP)
Dynamic Host Configuration Protocol (DHCP)
Reverse Address Resolution Protocol (RARP)
The switch makes BOOTP, DHCP, and RARP requests only if the
sc0 interface IP address is set to 0.0.0.0 when the switch
boots up. This address is the default for a new switch or a
switch whose configuration file has been cleared using the
clear config all command. BOOTP, DHCP, and RARP requests
are only broadcast out the sc0 interface.
Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What are the advantages of the Cisco integrated solution (Cisco 2600/3600 Series with ADSL WIC) over a two -box solution consisting of a router with an external DSL modem?
Tell me what is distance vector routing protocols?
What Cisco IOS Release is required?
Does the WIC require a splitter?
Differentiate ethernet switch and a hub?
How does the WIC support AAL2?
What is the ADSL WIC?
How does this WIC when installed into the Cisco 2600/3600 differ from the Cisco IAD2400 Series?
What are the advantages of the Cisco integrated solution (Cisco 1700 Series with ADSL WIC) over a two-box solution consisting of a router with an external DSL modem?
Why is it that sms/mo receives a sent and delivered acknowledgement but mt is not receiving the message?
What is the difference between routers and switches
Is PPPoATM supported?
What are the advantages of using PPPoE or PPPoATM?
Explain bridging?
Where do the Cisco 1700, 2600, and 3600 with ADSL WIC fit into the Cisco product line?