Answer Posted / p.s.suresh

1. first we will take filltered oil in test kit.
2. then maintained 2.5mm gap between electrode and applying
rated 40 & 60 Kv for 1 minite .
3. the above test withstood for 1 minite its ok for
energiseing the transformer.

how is working bearing heater?

1567

---

what is ATS & RING MAIN UNIT in Distribution System?And its Function.

1508

---

How servo stabilizer works.

1640

---

What are the components of feedback control system?

624

---

why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor

2073

---

---

What is inrush current? how can calculateit? what is the affect of it?

1547

---

Difference between Lugs and Thimbles

13776

---

what happen ehen synchronisation is done at below rated speed

1613

---

How stabilizer works??

1654

---

how ct burden,magnetising current,ratio and knee point voltage are related & derived

1762

---

I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.

1931

---

11000volt DG set carnt kaise banvay

1237

---

how to decide the capacity of accl

1917

---

what is active power & reactive power?

1720

---

if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?

2130

---