Answer Posted / keerthi vishnu vardhan
embedded system is the combination of both software and
hardware. this is also called firmware. we write coding with
using software, once performed execution will be burnt on to
the microcontroller.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
What happens when the intr signal goes high in the 8085?
What are the flags used in 8086?
What is an interrupt service routine in microcontroller?
What is instruction cycle?
What is the difference between 8085 microprocessor and a 8086 microprocessor?
What is the purpose of the biu in the 8086?
What is special purpose registers in 8086?
What are the widths of data bus (db) and address bus (ab) of 8085?
What type of memory is the stack?
State the differences between a procedure and a macro.
Why was 8085 microprocessor introduced?
What is address bus, data bus and control bus in microprocessor 8051 ?
What are the index registers in 8086?
Other than setb, clr are there any single bit instructions?
Explain memory mapped i/o and i/o mapped i/o schemes?
