hi vishok this is noor plz tell me what type problems will
occured i use T/C in the place of RTD in (FEED WATER
TANK),plz send ur e-mail address to my ID
(mail2noor.hyd@gmail.com)
- 6 Answers
- 6154 Views
- I also Faced
- E-Mail Answers
Answer Posted / solomon
No problem.costwise T/c better.accuracywise RTD better.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How can measure flow in oil line?which type of transmitter is generally used?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
how do we commission inergen system?
Explain the working of an enraf level gauge.
how to calculate the total flow in square root
what is the procedure of O2 sensor(ABB) calibration?
principle of automatic votage regulator
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Explain types of valves?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
How does your previous experience relate to the job you are applying for ?
