my field of interest is T&D. plz tell something about that.
Answer Posted / bidhan
best of luck.....
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Direction of flow of active power and reactive power with logic?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
What is vaccum currcuit breaker.define with cause and where be use it device?
Haw to check conductivity of budbar
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
What is sink and source?
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
how point on wave controller works.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
at what base you will tell the direction of rotation of dc motors and generators?
what is plunger and what's the use of it in motor alignment?