whats the diff b/w mpcb and mcb?weather it trips on single
phasing or not.
- 9 Answers
- 14942 Views
- Electra Power, Essar, I also Faced
- E-Mail Answers
Answer Posted / sayan
MPCB:Motor Protection Circuit Breaker, which performs the
same function as that of an SFU.
MCB:Miniature Circuit Breaker, It also functions as a short
circuit prevention device. It can be 1,2,3,4 poles
depending on the requirement.
| Is This Answer Correct ? | 12 Yes | 5 No |
Post New Answer View All Answers
What kind of maintenance is conducted for Transformer
What is the basic rule for block diagram reduction technique?
why star point of HT motor not earthed?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
How to calculate the fuse rating depend upon the DC circuit?
how to handle 2500 kva transformar
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
Meaning of ingrace protection for motor.for ex IPXY
what is the use of vcb & isolator in substation?
What is an order of a system.
can we synchronize star system generators with delta system generators?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
