For f = AB+CD if B is S-a-1, what r the test vectors needed
to detect the fault?
- 5 Answers
- 12253 Views
- Intel, I also Faced
- E-Mail Answers
Answer Posted / debapriyo
all zero vector will do
0000
| Is This Answer Correct ? | 2 Yes | 27 No |
Post New Answer View All Answers
For an AND-OR implementation of a two input Mux, how do you test for Stuck-At-0 and Stuck-At-1 faults at the internal nodes? (You can expect a circuit with some redundant logic)
What is the purpose of having depletion mode device?
What are the various regions of operation of mosfet? How are those regions used?
Draw the Layout of an Inverter?
What happens if we use an Inverter instead of the Differential Sense Amplifier?
What's the price in 1K quantity?
What are the Factors affecting Power Consumption on a chip?
Explain about 6-T XOR gate?
Draw the Cross Section of an Inverter? Clearly show all the connections between M1 and poly, M1 and diffusion layers etc?
Explain the Charge Sharing problem while sampling data from a Bus?
Explain how logical gates are controlled by Boolean logic?
If not into production, how far did you follow the design and why did not you see it into production?
Let A & B be two inputs of the NAND gate. Say signal A arrives at the NAND gate later than signal B. To optimize delay, of the two series NMOS inputs A & B, which one would you place near the output?
Differences between IRSIM and SPICE?
Explain the three regions of operation of a mosfet.
