Interested to Buy Any Domain ? << Click Here >> for more details...
what are the affects of loose connection in electrical
circuit.
- 14 Answers
- 65807 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / tauseef tarique, engineer(e)
Loose connection is the most Dangerous thing in the
electrical enginnering and one should always avoid it.
Due to loose connection the contact resistance will
increase and when the current flows through it, it will
start heating at the connection point and if the current
continues the contact point may melt and disconnect the
supply.
Because of sparking due to loose connection the instrument
connected with this line may be damaged.
| Is This Answer Correct ? | 57 Yes | 4 No |
Post New Answer View All Answers
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
3phase cable calculation formula by motor load
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
What is the abbreviation of NGT panel
how to convert lv line to hv line and viseversa, any losses will occur during this process
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
Disadventage of cable-gland earthing if any ?
what is the difference between the characteristics of two different phase bushing of any transformer
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
main difference between ac and dc?
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
