Answer Posted / welcome4ujd

make the calibration set up , to get -60 , give 60 in lp
sidethen adjust zero screw, give 20 in lp side toget -20
url , and adjust span screw.

Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.

1902

---

Identification of control valve parts.

2068

---

State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.

2054

---

TECHNICAL/ARTITUDE

2264

---

can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.

2277

---

Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?

1941

---

What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).

2163

---

why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?

2065

---

How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.

2155

---

I need to know steps to Calibration Valve Guard......

1500

---

what is the input to be given in digital flow meter during the the calibration time?

2244

---

Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system

1543

---

How many ohms are required for proper earthing?

1109

---

What is the PLC configuration in Cement industry?

3817

---

For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?

5472

---