what is the effect if we add capacitor on DG supply, it has
any loss or benefit.
- 6 Answers
- 11266 Views
- I also Faced
- E-Mail Answers
Answer Posted / niranjan
adding a capacitor ina dc supply is of no use
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
do we use links in a dc circuit?if so what s its use in it?
what are factors to be consider to design a HT & LT motor?
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
what is buffer resistance starter.?.What is the working principle and where it is used..?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
what is the electrical?
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
State kirchoff current law?
what is the difference between ups & inverter
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
