Answer Posted / bhanu
"5P 10" in this 5P Accuracy class,10 represents composite
error
| Is This Answer Correct ? | 14 Yes | 30 No |
Post New Answer View All Answers
How to Make relay co ordination chart for a Electrical power distribution of a plant
What are the basic elements used for modeling mechanical rotational system?
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
How phase displacement change in the over current relay coils.
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
How to assume answer to electrical questions
please send me last 5 year interview questions
PIU how does work?
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
what is the significance of tan&delta and how it performed in power transformer
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
