How can we calculate the fault level of the distribution
system knowing the percentage impedance of transformer &
subsequent equipments.
- 14 Answers
- 56051 Views
- I also Faced
- E-Mail Answers
Answer Posted / k n naidu
hi,
Calculation of fault level of a distribution net work of
complex in nature manually is laborious. Use network
analyser for simulating the network and fault at the
required bus to get the fault current.
for manual calculation use the MVA method which is
simple and gives fairly acurate results
| Is This Answer Correct ? | 23 Yes | 7 No |
Post New Answer View All Answers
On Which Pressure PRV is operated.
What is the type of feedback used in an op- amp schmitt trigger?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
How colour picturetube works & how many year it will works.
What is the lockout relay
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
what is feed back and what are feed back amplifiers?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
What is the Current equation in series RLC circuits.
how can i change the rotation of the AC single phase induction motor and show me by diagram
send me all basic electrical question and answers
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
why the check zone and main zone are used for Busbar Protn. scheem?
what is mean by parallel operation of permanent magnet generators
What are approaches to tackle sedimentation problem of reservoir?
