HOW DO YOU PROVE THE HIGH VOLTAGE CABLES OR BUSBAR IS DEAD
EVEN AFTER IT IS DE ENERGISED
- 6 Answers
- 13261 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhandapani muthu.r, je tneb, i
Unless otherwise it is discharged and earthed it should be
treated as energised. We have to discharge and eath that
bus or cable with a set of earth rods. Then only it is
proved. We could also use a remote sensor to prove that it
is dead.
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
what are the parameters plays a major role in Potential transformer Burden calculation??
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
What is the formula to calculate the size of Aluminium and copper cable?
what is efficient motors and how it is different from normal induction motors
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
what is the meaning of 0.5ohm Resistance
what does a string of resistors in a series will do?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
induction 3 phase motor terminal connection
where reactive power is used
if a number of plc s are there then how many modbus to be used
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
