OUR METER READER TAKE READING OF INDUSTRIAL CONSUMER.THEY
ALWAYS ASK HOW TO INCREASE POWER FACTOR FROM 60% TO 99 % TO
AVOID PENALTY OF POWER FACTOR.
- 3 Answers
- 6758 Views
- I also Faced
- E-Mail Answers
Answer Posted / t.mohan
POWER FACTOR = REAL POWER / REACTIVE POWER.KWH/KVRH.
FOR INCREASING POWER FACTOR PROVIDE CAPACITOR BANK AT
CONSUMER'S END.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how we can calculate the efficiency of a diesel generator ?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
what is plunger and what's the use of it in motor alignment?
How to calculat the ratio of HT\LT in energy meter
i want to know about torque of slip ring induction motor
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
boiler is running in rankine cycle and deisel generator is....?
what is the difference between vector scale and vector diagram?
What is accuracy of a measurement?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
