why DC current not used in Transformer action?
- 17 Answers
- 19302 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / sa
DC source having Zero Frequency.
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
where solid grounding and where grounding through ngr done and why?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
How to back charge the Gas turbine generator
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
1.how many types of relays? 2.difference between ATS& STS?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
how to decide the capacity of accl
What is negative sequence over voltage element?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
what r the checklist while installing 500 kva transformer
what type questions asked in hp cl
working function importance of mdc meter
