Is it true that IPT are more accurate than CVT for
Measuring purpose?
- 2 Answers
- 3679 Views
- I also Faced
- E-Mail Answers
Answer Posted / gan2009
CVT- Capacitor voltage tranformer mainly used in EHV
network.It has certain advantage over Electromagentic
VT,BUT accuracy vice my opinion is both are almost same.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
why HT armoured cable does not glanding
Inductor and capacitor........power in one phase and ...... in it another phase.
What is the main purpose of c.f.b.c.boiler
What are the two major types of control system?
how power is generated,and transmitted to our home..pls explain briefly in simple words.
why capacitive load is not used in routine life????any reason is there ??????
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
Whether power factor should be high or low? Why?
Which material is used for the core of a transformer and why?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
Benifits of 3ph 4 wire metering over 3ph 3 wire
