Is it true that IPT are more accurate than CVT for
Measuring purpose?
Answers were Sorted based on User's Feedback
Answer / gan2009
CVT- Capacitor voltage tranformer mainly used in EHV
network.It has certain advantage over Electromagentic
VT,BUT accuracy vice my opinion is both are almost same.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / selvaraj
CVTs are normally used where there is a need for
communication is contemplated.
They are prone for errors in due to aging.
It is comparatively cheaper.
Always prefer IPT for measurement which are tariff related.
Is This Answer Correct ? | 0 Yes | 0 No |
what is formula of dc current and resistance.
wchich motor we are using in mixer?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
what is diffence between synchronus and asynchronus AC motor.?
Do I need a special Transformer to put 240 VAC 3 phase into it and and get 480 VAC 3 phase out of it to run a machine? Or, do I just use an ordinary step down transformer and step up the voltage? Thanks
What is reason of rating of transmission line multi pal of 11 like as 11/33/66/220 ? Why not use 75 kv 23 kv line in power system ?
1 Answers Apollo, Balco, Bhel, Vardhman,
What is meant by vector group
0 Answers GPSC Gujarat Public Service Commission, VA Tech Wabag,
What is ONAN/ONAF1/ONAF2 for transformer cooling
On load tap changer (OLTC) explode? Transformer Vector group: Ynd11 Rated Power: 353MVA Rated Current: 693A Voltage:294/20KV OLTC Type: T III Y1000 110/c 12193w Max Operation Current: 295A Step Voltage: 550V Arrangement in Tx windings: Y Connection Problem: Damage of Unit 1 Generator Transformer On Load Tap Changer (OLTC) Description of Incident: 9.00 a.m. :- Generator No Load test on excitation system started 10.30 a.m :- Carried out AVR change over test 11.30 a.m :- Preparation for Generator Manual Synchronizing test 12.00 a.m :- Manual Synshronizing test started. Observed incoming generator voltage higher than running voltage. CECR operator operated Generator Transformer OLTC to bring down the incoming generator voltage 12.03 a.m :-Generator Transformer abnormal alarm operated at Gen.Control Desk (CECR) CECR operater at Generator transformer bay informed that the transformer oil splashed out from OLTC. CECR operater informed that he heard explosion inside OLTC. Observed Oil level & Oil Flow alaram operated at Tranformer local annunciator. 12.05 am :- CECR operator 'Open Gen Field Breaker” 12.10 a.m. :- Elec1 team inspected the OLTC and found the OLTC rupture disk was broken and oil spilled at OLTC area. - Elec1 found the OLTC top cover bulging. Do anyone know why and possibility cause happen in this OLTC.
why frequency should be constant?
howmany insolaters needed in 66kv line
WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?