In step down transformer (415/200V),mistakenly secondary
side is connected to 415V for some hours, what would be
result of this condition?
- 19 Answers
- 24305 Views
- Essar, GAIL, Vizag Steel, I also Faced
- E-Mail Answers
Answer Posted / rvg
The current at 200v side will be more than what designed
for the transformer and core loss will be more. So
ultimately,transformer will be heated up more faster than
ordinary condition. Depends upon the insulation used for
core construction, and how long u are connected the supply,
there r chances of insulation failiure.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
WHY RATING OF VCB NOT LESS THAN 630A
What is Phase margin?
what is the condition for YnD11
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
How are load losses and no-load losses measured at site in a DG set?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
what is basic difference betmeen normal & flame proof motor??
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
what is the use of the circle diagram
how to check regenerative load in drived motor
What is the formula to calculate the size of Aluminium and copper cable?
can the measured percentage error during calibration of single phase energy meter be negative?
