what happens when ac supply is given to D.C motor.
- 17 Answers
- 27826 Views
- I also Faced
- E-Mail Answers
Answer Posted / mr.anant ram yadav
if A.c. supply given to D.c. motor the net torqe will be
zero and motor will not work. bez postive &negative cycle
is zero.
| Is This Answer Correct ? | 19 Yes | 14 No |
Post New Answer View All Answers
Why hydropower stations are preferred solution for meeting peak loads in grids?
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
How one can check the MAIN of a house wiring ?
how to select battery for 15 KVA UPS with formula
what is the function of statics switch in ups and tell me parts
How DC earth leakage currents can be reduced ?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
What is dc current source?
How is the gain affected by the introduction of feedback in a control system.
What is Control & Relay Panel? And Remote Control Center?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are the advantages of a three-phase system over a single-phase system?
Inductor and capacitor........power in one phase and ...... in it another phase.
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
