Wht ar the reason for low voltage on consumer side?
- 6 Answers
- 7663 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinay gupta
A consumer may suffer from low voltage because of one or
more following reasons:
1.Due to power generation at low voltage at generating end.
2.Due to low power factor, bcoz of which more current to be
carried out for meeting the same load and hence line losses
increases which is responsible for the low voltage.
3.Due to over load.
4.The voltage drop across the conductor or cables is the
major cause of low voltage.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
Why the output of OP-AMP is always less than Vcc?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
Explain what is electric traction? Explain few advantages of electric traction system?
Tell me all plants load factors i.e which plant operating on which load?
In how we connect watt meter for open & short circuit test of a single phase transformer.
how to get electrical supervisour certificate in gujarat
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
Why we are going for converter transformers for DC drives application instead of distribution transformer?
im electrical engineer, could any one help me for FEWA exam questions please ?
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
What is power relay?
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
