What is the formula for finding fault level of generator?
- 11 Answers
- 35148 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhiren patel
what is the refected current in 6.6 KV system in case of 11
kv side fault current is 40 KA and 8000 A full load current.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How to calculate VCB rating for 33KV ,25 MW Power line?
What is marx circuit?
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
What is instrumental error?
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
1.What will be stored in online ups EPROM IC?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
which is the best institute for PLC,SCADA,DCS in hyderabad
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
Define the three phase formula fuse.
