HOW TO CALCULATE THE SIZE OF CABLE COPPER & ALUMINIUM
- 11 Answers
- 64239 Views
- Amman Try, Prestige, I also Faced
- E-Mail Answers
Answer Posted / kalirajan.n
***SUPPOSE WE USE COPPER CONDUCTOR AND WE ALLOW A MAXIMUM OF
5V MAX. VOLTAGE DROP:
5= 2*12*15*230/CSA
CSA= 82800/5
CSA= 16560 CM
FROM COMMERCIAL REFERRENCES:
15560 CM IS CLOSEST TO 16510 CM WHICH IS #8 COPPER OR 8 SQMM
WIRE.
NOTE:
1. IN THIS CASE A MAXIMUM OF 5 VOLTS WAS CONSIDERED IN THE
CALCULATION.
2. THIS CALCULATION IS NOT VALID FOR LARGE MOTORS. BECAUSE
MOTORS DRAWS A MAXIMUM OF 7OO% TIMES ITS FULL LOAD TORQUE
DEPENDING ON THE MOTOR CONTROL STARTING METHODS USED BY THE
DESIGNING ENGINEER.
| Is This Answer Correct ? | 14 Yes | 8 No |
Post New Answer View All Answers
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
How earthing of switchgear system to be done.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
What is big transformer parts and their function ? Ty
Define the term Capacitance and Inductance?
what is a reactive power? what is the relation with power factor?
What is proportional controller?
can i use the six sigma method which is used in management area, in state estimation of power systems?
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Why collecting electrode of ESP to be earthed
what is mean by restructuring power system?
Why arc quenching is used in Diode ?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
