there is three mode of vtp let there are three switch s1 in
server mode s2 in transparent mede and s3 in clint mode
then will that tranparnt mode going to effect the network if
yes then how and if no then what it will do
Answers were Sorted based on User's Feedback
Answer / tatyasaheb
No..........it does not make effect it simply transfer vlan
detail frm server to client according to its revission no.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / anil
yes because in transparent mode information is not synchorized
Is This Answer Correct ? | 3 Yes | 2 No |
Name the command we give for see routing table?
Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
What does the trace response !H mean? * A: Network unreachable * B: Not forwarded due to ACL restriction * C: Protocol unreachable * D: Port could not be reached
Hi, If we create more Gateway from one our Router Interface Gateway (Example: by set up a ISA server etc) will it effect on our bandwidth to be low? please help me
What is the last step in data encapsulation? A.) User information is converted into data. B.) Segments are converted into datagrams and packets. C.) Frames are put into bits. D.) Data is converted into segments. E.) Packets are put into logical frame.
What type of Ethernet operation allows only one entity to transmit at a time? For example, if someone else is transmitting, they must wait. A.) Full-Duplex B.) Dual-Duplex C.) Half-Duplex D.) Latex E.) Quarter-Duplex F.) Suplex
what is the diffination of bandwidth.
Which way of communication bus topology use?
What is the diiffernce between windows xp & windows 2000?
6 Answers TCS, Trimax, Trymax, VigaTech,
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
When we do default route?