What is the passive topology in ccna?
No Answer is Posted For this Question
Be the First to Post Answer
Name a major component of the Point-to-Point Protocol (PPP) to negotiate and set up control options on the WAN data link. A.) RFC 1661 B.) High Level Datalink Protocol (HDLC) C.) Challenge Handshake Authentication Protocol (CHAP) D.) SS7 E.) Link Control Protocol (LCP)
Which command will enable CHAP authentication on a serial interface that is using PPP? A.) encapsulation chap B.) ppp chap C.) ppp enable chap D.) ppp encapsulation chap E.) ppp authentication chap F.) ppp chap enable
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
if 10 pc's connected from internet, in 8 pc's internet is correctly run but in other 2 pc's they can not access internet,what's the problem?
Which protocol you manually enable route summarization?
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
The CSMA/CD Ethernet IEEE committee is defined as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5
What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network
Identify the purpose of the Trace command? A.) Explorer packet transmitting routing information B.) Test connectivity C.) Determine the path a packet is taking through the network D.) Transmits user data when buffers are full
What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services
What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route