HI I am Rajveersinh. I am Leaving in Ahmedabad-gujarat. I am Hardware & Networking Stundent In JETKING. my Intersted in CICKO Side. Please send ME totel detail in CICKO surtifiction my E-mail ID IS as_raj@ymail.com

6 Answers   HCL,

---

What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip

6 Answers  

---

Which statement about the flow control function of TCP is true? A. TCP makes no snarl to check for lost or duplicate data packets B. The application layer must sequence data packets when using TCP C. TCP controls the flow of UDP data through negative acknowledgements (NAK) D. TCP is a connection-oriented protocol that acknowledges receipt of data packets and is considered reliable

1 Answers  

---

1-what is the diffrence between hdlc and ppp protocol 2- why frame realy technogy called NBMA

4 Answers   Brigade,

---

Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  

---

Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation

2 Answers  

---

Which cable called roll-over?

0 Answers  

---

Explain the term 'broadcast'.

0 Answers  

---

Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2

1 Answers  

---

What do you mean by Port Mirroring?

0 Answers  

---

Tell me which cable we connect in db-9?

0 Answers  

---

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. mac-address 0005.1b00.5b58

4 Answers  

---