Which addresses are INCORRECTLY paired with their class? A. 128 to 191, Class B B. 192 to 223 Class B C. 128 to 191, Class C D. 192 to 223, Class C

3 Answers  

---

Identify 2 functions of IPX access-lists? A.) Control SAP traffic B.) Limit number of Novell servers on a network C.) Limit number of workstations on a network D.) Block IPX traffic

1 Answers  

---

what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain

5 Answers   IBM,

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

1 Answers  

---

What is the purpose and default value of the CDP timer command? A.) 90 seconds; interval before an entry expires B.) 60 seconds; interval between updates C.) 60 seconds; interval before an entry expires D.) 90 seconds; interval between updates

1 Answers  

---

What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds

1 Answers  

---

What are the difference between IPv4 & IPv6?? Can anyone explain more details about it..!!

9 Answers   HCL,

---

The network portion of an address typically represents a: A.) Router B.) Ethernet MAC address. C.) Computer D.) Host E.) Segment

3 Answers  

---

What are the ranges for the private ips?

0 Answers  

---

Identify 3 Fast Ethernet technologies? A.) 100 Base FastEther B.) 100 Base FX C.) 100 Base T4 D.) 100 Base TX

1 Answers  

---

What is a vlan? What does vlan provide?

0 Answers  

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---