Which cable we connect in db-9?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More CCNA Interview Questions

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers  


What requirements should a VPN fulfill?

0 Answers   CCIE,


Define the virtual channel?

0 Answers  


What is the best Difference between RIP, OSPF, EIGRP

7 Answers   Airtel, Gemini, HP,


What s the formula for metric of ospf?

0 Answers  






Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 Answers  


When you issue the command show version your router returns "Configuration register is 0x0101" From where does the router boot? A. ROM B. NVRAM C. Flash D. a TFTP server

3 Answers  


Select the compression protocols for PPP? A. Stac B. Predictor C. Quality D. Magic Number

1 Answers  


Can you explain PPP packet format?

0 Answers   CCIE,


can we configure multiple as on single router using eigrp

1 Answers   IBM,


Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Router# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers   ABC,


On Cisco catalyst 5000 how would you set the second port on the controller in the first slot to full duplex? A.) Set port duplex 1/1 full B.) Set port duplex 1/2 full C.) Set port duplex 0/1 full D.) Set port duplex 0/2 full

2 Answers  


Categories