Identify command that configures 'Cisco1' as a secret password? A.) Router(config)# enable secret password Cisco1 B.) Router(config)# enable secret cisco1 C.) Router(config)# enable password Cisco1 D.) Router(config)# enable secret Cisco1

2 Answers  

---

Explain the difference between static and dynamic routing?

0 Answers  

---

What does the command “IP name-server 255.255.255.255″ accomplish? a.It disables domain name lookup. b.It sets the domain name lookup to be a local broadcast. c.This is an illegal command. d.The command is now defunct and has been replaced by “IP server-name ip any”

5 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

3 Answers  

---

2. What are the valid ways to segment a LAN? (Choose all that apply) A. Repeater B. Bridge C. Switch D. Router

2 Answers  

---

---

switch kitne volt per work karta hai. what is frame realy. what is isdn and pri and bri.

3 Answers   CMS,

---

What is the difference between static and dynamic ip addressing?

0 Answers  

---

what is difference between hub and switch?

7 Answers   IBM,

---

What is the difference between the switch, hub, and router?

0 Answers  

---

CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office

1 Answers  

---

When a router knows the IP address, but does not know the MAC address of the device it wishes to contact, it uses the ARP (Address resolution protocol) to determine the MAC address. After it learns the MAC address, it stores this information in the ARP cache. What is the command to view the ARP cache? A.) sh mac B.) show cache C.) show arp D.) sh arp interfaces E.) show ip cache

2 Answers  

---

Which statement is true? A. While bridges are used to segment networks, they will not isolate broadcast or multicast packets. B. A bridge looks at every packet within its network segment and works like a hub re-broadcasting the packet if the destination is within its network segment. C. A bridge maintains a table of the IP addresses of the hosts within its network segment and forwards the packet directly to the destination based upon the IP address. D. A bridge resets the hop count by keeping all packets within the network segment. Only packets addressed to a specific destination host outside the network segment are allowed to pass through the bridge.

1 Answers  

---