Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged the are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination

1 Answers  

---

What does protocol mean?

0 Answers  

---

How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64

1 Answers  

---

Given the Novell IPX address 1aceb0b.0000.0c12.3456 which part is the network portion of the address? A.) 0000 B.) 1 C.) 3456 D.) 1ace E.) 0000.0c12.3456 F.) 1aceb0b

2 Answers  

---

At which layer of the OSI Reference Model do bridges operate? A.) Physcial B.) Session C.) Datalink D.) Transport E.) Network

2 Answers  

---

Which of the following is an example of the Physical Layer? A.) SQL B.) IP C.) LLC D.) Token Ring E.) FDDI F.) TCP

2 Answers  

---

Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.

2 Answers  

---

Identify the 3 kinds of routes IGRP advertises? A.) Interior B.) Dynamic C.) System D.) Exterior

1 Answers  

---

What is segmentation and fragmentation?

0 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

When does network congestion occur?

0 Answers  

---

what is difference between designated router and backup designated router and explain feature of both router.

6 Answers   HCL, IBM,

---