When we use interface mode?
No Answer is Posted For this Question
Be the First to Post Answer
Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises
Which layer is responsible for coordinating communication between systems? A.) Application B.) Network C.) Session D.) Transport E.) Physical F.) Data Link
Tell me which protocol comes under hybrid dynamic type?
Which protocol carries messages such as destination Unreachable, Time Exceeded, Parameter Problem, Source Quench, Redirect, Echo, Echo Reply, Timestamp, Information Request, Information Reply, Address Request, and Address Reply? A. ICMP B. UDP C. TCP D. TFTP E. FTP
Hi Guys I am facing one problem while configuring PAP over Point to Point links. Configuration scenario is like this. ROUTER 1: (Hostname – R1) R1(config)#username R2 password CCNA2 R1(config)#interface serial 1/1 R1(config-if)ip address 10.0.0.1 255.0.0.0 R1(config-if)#lock rate 64000 R1(config-if)#encapsulation ppp R1(config-if)#ppp authentication pap R1(config-if)#ppp pap sent –username R1 password CCNA1 R1(config-if)#no shutdown ROUTER 2: (Hostname – R2) R2(config)#usename R1 password CCNA1 R2(config)#interface serial 1/1 R2(config-if)#ip address 10.0.0.2 255.0.0.0 R2(config-if)#encapsulation ppp R2(config-if)# ppp authentication pap R2(config-if)# ppp pap sent –username R2 password CCNA2 R2(config-if)#no shutdown Now problem is that, after configure the command “ppp authentication pap” the “Line protocol” status goes down on each router. But when I disable this command using “no ppp authentication pap”, the “Line Protocol” status goes up. What could be the problem, can anyone explain it plzzz….!!! Thanks in Advance…!! Shahin..
When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
NetWare IPX addressing uses a network number and a node number. Which statements are true? A. The network address is administratively assigned and can be up to 16 hexadecimal digits long. B. The node address is always administratively assigned. C. The node address is usually the MAC address. D. If the MAC address is used as the node address, then IPX eliminates the use of ARP.
What is the command to manually enter a static route? A.) IP route network B.) IP route C.) IP route < destination network> D.) IP route
Identify the protocol to test connectivity without configuring any layer 3 protocols? A.) TCP B.) Ping C.) IP D.) CDP E.) Telnet
Value in which type of access list?
What is the draw back of ospf protocol?
How many total hosts are possible with a Class C address and a subnet mask of 255.255.255.252? A. 4 B. 30 C. 60 D. 62 E. 112 F. 124