Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.

2 Answers  

---

What is the multicast routing?

0 Answers  

---

What are the advantages of lan switching?

0 Answers  

---

How does inter- VLAN communication take place? A. It takes place through any Cisco router B. It takes place through a Cisco router that can run ISL C. It takes place through a router but this disables all the router a security and filtering functionality for the VLANS D. For nonroutable protocals (e.g. NetBeui) the router provides communications between VLAN domains E. Inter-VLAN communication is not possible because each VLAN is a separate broadcast domain

3 Answers  

---

Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory

2 Answers  

---

Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged the are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination

1 Answers  

---

mention the funtions about connection oriented and connectionless protocol and how it works ?

7 Answers  

---

Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'

3 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

2 Answers  

---

How many collisions are caused by transmitting and receiving frames simultaneously in a full-duplex Ethernet technology? A. one B. two C. none D. several

1 Answers  

---

Which statement should you use to deny FTP access (only) from network 210 93 105 0 to network 223 8 151 0? A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access list 1 permit any B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp access list 100 permit hp any any D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp access list 100 permit ip any any

1 Answers  

---

Can you explain the broader steps of how L2F establishes the tunnel?

0 Answers   CCIE,

---