Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following is not true in regards to route
summarization?
A. It increases the size of the routing table
B. It increases the complexity of the network
C. IP networks must be contiguous to be safely summarized
D. Routing tables must have the capacity to support
classless routing
- 1 Answers
- 4032 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
Route summarization DECREASES the size of the routing table
by combining multiple routing table entries into single
routing entry. The complexity of the network is increased
because you have to deal with contiguous addressing, parts
of the summary becoming disjoint, if more specific routes
leak out on another path the longest subnet match will drive
traffic there.
| Is This Answer Correct ? | 1 Yes | 0 No |
What happens to performance if the maximum MTU (Maximum Transmission Unit) size is used? A. Performance increases B. Performance decreases C. Performance stays the same D. Performance has nothing to do with the MTU
when ever we apply show flash comand on the router it givesthat informatin router#show flash syatem file directory: file length name/status 1 8121000 c2500-js-L.112-18.bin what does it nean plz help i have read it from book but not bale to understand i am looking towards u for the help
What device initiates a session in an X.25 network? A. DTE B. DCE C. PSE D. PAD
The following are the four steps in establishing an X.25 virtual circuit. Place them in the correct order. A. The PSE (Packet Switch Exchange) passes the packet to the next remote DCE B. The local DCE packet binder sends packet to the closest PSE (Packet Switch Exchange) C. The source DTE sends packet to the local DCE D. The remote DCE examines the packet header of destination DTE
What are two differences between 10BaseT and 100BaseT? A. Speed B. Frame format C. Addressing D. Network diameter
What is the technique used by a router that can automatically initiate and close a circuit-switched session? A. PLP B. LAPP C. ASN.1 D. DDR
When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices
How many networks will be advertised using route summarization within an OSPF network if you are given the following networks? 192.108.168.0 192.108.169.0 192.108.170.0 192.108.171.0 192.108.172.0 192.108.173.0 192.108.174.0 192.108.175.0 A. 1 B. 2 C. 3 D. 4 E. 5
What are two true statements regarding DDR (Dial-on-Demand Routing)? A. Allows a router to automatically initiate and end a circuit-switched session B. DDR cannot be configured because it is set with a default configuration C. Can configure it to be used during non-peak hours D. Can only be used with Cisco PIX
Diagramming application information flow is important because: A. it helps identify heavy traffic paths B. it helps figure out why email gets from one place to another C. it can tell you when to purchase a new router D. it can tell you when to purchase a new switch
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
A remote user needs a static IP address to support a specific application.Which remote access VPN addressing technique supports this ?
CCNA 
