Interested to Buy Any Domain ? << Click Here >> for more details...
Which IP address is not a private address?
A. 142.18.0.0
B. 10.0.0.0
C. 172.16.0.0
D. 192.168.0.0
- 1 Answers
- 3378 Views
- NetMax, I also Faced
- E-Mail Answers
Answer / guest
Answer: A
142.18.0.0 is not a private address. The remaining IP
addresses are private and are used when the machines do not
need to connect to the global Internet.
| Is This Answer Correct ? | 6 Yes | 0 No |
Which address is updated at each hop in the path in path switching?
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
What happens to performance if the maximum MTU (Maximum Transmission Unit) size is used? A. Performance increases B. Performance decreases C. Performance stays the same D. Performance has nothing to do with the MTU
What is an advantage of CHAP over PAP? A. Passwords are stored on separate servers in encrypted form B. CHAP sends passwords unencrypted to save connection time C. CHAP does not attempt to verify whether the user is authorized to access the requested resource D. ID?s and passwords are automatically stored in cache
Diagramming application information flow is important because: A. it helps identify heavy traffic paths B. it helps figure out why email gets from one place to another C. it can tell you when to purchase a new router D. it can tell you when to purchase a new switch
What are two true statements regarding DDR (Dial-on-Demand Routing)? A. Allows a router to automatically initiate and end a circuit-switched session B. DDR cannot be configured because it is set with a default configuration C. Can configure it to be used during non-peak hours D. Can only be used with Cisco PIX
The following are examples of proactive network management except: A. Allocate sufficient staff time B. Troubleshooting and solving system problems C. Generate reports D. Identify Problems
Which router would you choose for your design? A. 1600 B. 1700 C. 3600 D. 3640 E. 7200
The following are the four steps in establishing an X.25 virtual circuit. Place them in the correct order. A. The PSE (Packet Switch Exchange) passes the packet to the next remote DCE B. The local DCE packet binder sends packet to the closest PSE (Packet Switch Exchange) C. The source DTE sends packet to the local DCE D. The remote DCE examines the packet header of destination DTE
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
What is the first step in diagramming packet flow for the terminals within a network? A. Identify the end user nodes of all the terminals B. Figure out the speed of all the servers C. Find out where all the routers are located D. Find out where all the switched are located
How can change k-value in EIGRP configuration.
CCNA 
