What is the maximum number of subnets that can be assigned
to networks when using the address 172.16.0.0 with a subnet
mask of 255.255.240.0? (Assume older version UNIX
workstations are in use.)
A. 16
B. 32
C. 30
D. 14
E. It is an invalid subnet mask for the Network.
- 2 Answers
- 7310 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
b Which protocol for PPP LCP (Link Control Protocol) performs a challenge handshake? A. CHAP B. PAP C. UDP D. IPX
How is private ip different from public ip?
What do you understand by poe (power over ethernet)?
Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free
can we measure how much a host exact bandwidth using by a network cable which is communicating over the network? options: 1- via Router 2- Switch, 3- other device... if yes.. then how ( with every option)
What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC
Which of the following is a characteristic of a switch, but not of a repeater? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet
What is the point-to-point protocol in ccna?
in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please
what is the boot seqance of cisco router
Explain the difference between bus topology and hub?
Which statement about the Committed Information Rate (CIP) is true? A. It is the rate in bits per second at which the Frame Relay switch agrees to transfer data B. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay cloud C. It is the maximum number of bits that switch can transferduring any Committed Rate Measurement Interval D. It is a signaling standard between the 3PE device and FP switch. It is responsible for managing the connection and maintaining status between the devices.
CCNA 
