With one method for transmitting frames through a switch,
the switch receives the complete frame and checks the frame
CRC before forwarding the frame. What is the switch
transmission method called?
A. CSMA/CD
B. Full Duplex
C. Cut-Through
D. Half-Duplex
E. Fragmentation
F. Store and Forward
- 2 Answers
- 4016 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'
what is difference between packet switching and circuit swtching
How many fillers we can put in one ip of ipv6?
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
Which memory component on a Cisco router contains the dynamic system configuration? ROM NVRAM Flash RAM/DRAM
Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network
What command do we give if router ios is stucked?
What layer can optionally support reliability? A.) Transport B.) IP C.) Physical D.) Network E.) Sub-physical layer
What is a Window in networking terms?
as i m cccna holder ... then why i m going for bpo's ?
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup
please name some routed protocol.
CCNA 
