Interested to Buy Any Domain ? << Click Here >> for more details...
Which type of switching reads in the entire frame before
forwarding it?
A.) Pause-and -forward
B.) Store-and-Forward
C.) Inverse ARP
D.) Fast Forward
E.) Cut-Through
F.) Routing
- 2 Answers
- 5217 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC
Hi all of you, Actually this is interview qe? but i did,t do explain it completely so please give reply recently and completly Ans, what is sub-interface and inter-vlan ? And How to implement it on cisco router & switches and also which series router switches supported please write..........
hi friend i hav difficulty n need to solve it...v need to implement a new raw switch in company as to increase the no of staff...snc raw switch by default is in server mode,i wanna know 1.how to make a switch in client mode...2.how to configure switch i mean to sy how to connect all switches to network.
Explain the difference between bus topology and hub?
Which of the following use PVCs at layer 2? A.) X.25 B.) HDLC C.) Frame relay D.) ISDN
Identify the command that configures serial0 for PPP encapsulation? A.) Router(config)# encapsulation ppp B.) Router(config-if)# encapsulation serial ppp C.) Router(config-if)# encapsulation ppp D.) Router# encapsulation ppp
You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router
Can 2 different VTP Domain Communicate. if yes then How.
hello friend i have answerd more time of your question or doute.now i am seeing towards you for help,plz send the soln before monedya the problem is i have three router r1 and r2 and r3 they are conested in that maneer thai is r1---r2---r3---server | | server bothe server have diffrent ip now i have to implemnt access list on the r3 router in such a way that user from r1 can access only one server while user from r2 can access whole servre i ahve done it but both user of r1 and r2 uses all server i need help please help me this time? i have repalsced my firwall by r3 router so bacicaly i have to implement it on my firewall but you tell me on cisco router please help
You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp
What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace
What cable called v.35?
CCNA 
