If a frame is received at a switch and only the destination hardware address

If a frame is received at a switch and only the destination
hardware

address is read before the frame is forwarded, what type of
switching

method is this?

A.) Store-and-drop

B.) Latency

C.) Store-and-forward

D.) Cut-through

Question Posted / guest

2 Answers
6009 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

If a frame is received at a switch and only the destination hardware address is read before the ..

Answer / guest

Answer: D

Is This Answer Correct ?

3 Yes

2 No

If a frame is received at a switch and only the destination hardware address is read before the ..

Answer / vinay

answer : c

in store and forward the complete frame is stored and the
forwarded to the destination at this process it will check
complete details of the frame.....and then forwarded to the
destination.

Is This Answer Correct ?

1 Yes

1 No

Post New Answer

More CCNA Interview Questions

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

2 Answers

Why OSI layers having 7 layers instead of one layer.

8 Answers HCL,

Which three functions are supported by connection oriented servkps? (Choose three) A. connection parameters are synchronized B. any loss or duplication of packets can be corrected C. the data packet is independently routed and the service does not guarantee the packet will be processed in order D. a data communication path is established between a requesting entity and the peer device on the remote end system

1 Answers

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers

What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #

1 Answers Sun Broadband,

What is the difference between csma/ca?

0 Answers

What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable

2 Answers

Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?

2 Answers

What is the command for change serial cost?

0 Answers

Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?

0 Answers

Explain the difference between igp and eigrp?

0 Answers

Identify command that configures 'Cisco1' as a secret password? A.) Router(config)# enable secret password Cisco1 B.) Router(config)# enable secret cisco1 C.) Router(config)# enable password Cisco1 D.) Router(config)# enable secret Cisco1

2 Answers

For more CCNA Interview Questions Click Here