Answer / guest

Answer: A B C D F

You are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem? A. NetWare 4.11 defaults to 802.2 encapsulation. B. NetWare 4.11 defaults to 802.3 encapsulation C. Cisco routers only work with NetWare 3.11. D. NetWare 3.11 defaults to 802.2 encapsulation.

1 Answers  

---

How does rip differs from igrp?

0 Answers  

---

When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?

2 Answers  

---

Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network

2 Answers  

---

Can you explain what IPSec is

2 Answers   CCIE,

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

1 Answers  

---

Why we are not using subnet mask of class A in class C?before answering this question, just think upon if we do this then we don't need to move to IPv6.

2 Answers  

---

3 router configured with RIP & Ripv2 rotuer 1- connected with router 2 having sr ip 10.0.1.2 routing : ripv2 router 2: connected with router 1 and router 3 having sr 0 ip 10.0.1.3 & sr 1 ip 11.0.1.2 routing :rip & ripv2 router 3: connected with router 2 having sr ip 11.0.1.3 routing: rip is there communication possible btween these networks ? if yes how

2 Answers  

---

Which OSI layer provides mechanical, electrical, procedural for activating, maintaining physical link? A.) Presentation B.) Network C.) Application D.) Physical E.) Transport F.) Data-Link

2 Answers  

---

What does the term "attenuation" mean in data communication? 1 loss of signal strength as distance increases 2 time for a signal to reach its destination 3 leakage of signals from one cable pair to another 4 strengthening of a signal by a networking device

3 Answers  

---

The CSMA/CD Ethernet IEEE committee is defined as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5

2 Answers  

---

Sequence and acknowledgement numbers are used for? A.) Layer transitioning B.) Flow control C.) Port number addressing D.) Reliability

1 Answers  

---