Answer / guest

Answer: C

Answer / prasanna

C
trace
ip path
redundancy protocol

Hi -All Can you tell me About of NAt (Network Address Tranlator) bcoz i have no idea about this topics Such as local ip , global ip and all plz provide the deatil of this topics

3 Answers  

---

Identify the command to display the configured IP routing protocols? A.) show protocols B.) show protocols all C.) show routing-protocols D.) show ip protocols

2 Answers  

---

How do you find valid hosts in a subnet?

0 Answers  

---

Which of the following protocols are used for logical network addressing? A.) IP B.) TCP C.) ARP D.) ICMP E.) RARP F.) BootP

1 Answers  

---

Which two steps are required to confound and apply standard access lists on an interface? (Choose two) A. define an access list number and its parameters B. enable an interface to become part of the access list group C. define the number of access lists to be supported on an interface D. copy the access list definition to each interface that will support it

2 Answers  

---

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

3 Answers   Cisco,

---

Define the virtual path?

0 Answers  

---

what is the diffrence betwwen telnet and ssh.this question is asked by nikhil and i am plasing the answer here insteed of his personal mail.

4 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

2 Answers  

---

what is farme realy.and on which layer it work

3 Answers  

---

Which command will show you if you have a DTE or DCE cable connected to an interface?

4 Answers   DFSS,

---

Which command will display the current time on a Cisco router? A.) show date B.) show clock C.) show running-configuration D.) show time E.) show controllers

2 Answers  

---