Which statement is true regarding the user exec and privileged
exec mode?
A.) The '?' only works in Privileged exec
B.) Privileged exec is a subset of the user exec mode
C.) They both require the enable password
D.) User exec is a subset of the privileged exec mode
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
Can anyone explain the Split Horizon rule in RIP & also Split Horizon with Poison reverse. Jitu.... U knw wat i expect.. hehehehehe...
Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual
What would be the proper wildcard mask to permit all odd numbered hosts on the 10.48.0.0/12 network? access-list 1 permit 10.48.0.0 0.15.255.255 access-list 1 permit 10.48.0.1 0.15.255.254 access-list 1 permit 10.48.0.0 0.15.255.1 access-list 1 permit 10.48.0.0 0.0.0.254 access-list 1 permit 10.48.0.0 0.0.0.255
What is difference between routing and routed protocols?
What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category
hello sir , if i finish this certification is the job is conform ?? and in chennai were i can do this ??
How arp brings mac address for switch?
take a pen and copy before solving that question there is a router name Ra there is two switch sw1 and sw2 sw1 is coneceted through fa0/1 interface of router Ra sw2 is conected through the fa1/1 serai interface of router s0/1 conected through the isp with it ip address 192.168.1.1 now therer are three host conexted through the sw1 and having ip host1=10.1.2.1 host2=10.1.2.2 host3=10.1.2.3 now there is also 3ree host conected through switch 2 i.e sw2 having ip host4=10.1.1.1 host 5=10.1.1.2 host 6=10.1.1.3 now i think u have made corect confrigation.now questios is started network admin configure the Ra router in that fassion Ra(config)#access-list 2 permit 10.1.1.0 0.0.0.255 Ra(config)#line vty 0 4 ra(config)#access-class 2 in now question is that why should network admnistratoe do it in this maneer A to give access sw1 host to acess internet B to prevent sw1 host from acessing comand promt c to prevent sw2 host from accessing console of router ra D to give sw2 host access to the enternet e prevent sw1 host from accessing internet f to prevent sw1 host from acessing the sw2 host network isp------(s0/1)..RA..(fa1/1)---SW2-host (4,5,6) | | (sw1)------host 1,2,3 this is not exect digarm but help to derive the diagram plz answer as soon as possible
How does RIP differ from IGRP?
Define osi?
Which ipsec rule is used for the olympia branch and what does it define?