Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the command to determine if CDP is enabled?
A.) show enable cdp
B.) show cdp enabled
C.) show cdp run
D.) show cdp
- 1 Answers
- 3721 Views
- I also Faced
- E-Mail Answers
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
Can you explain IKE phases? Can you explain IKE modes?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000
EIGRP send query reply & Acknowledgment on which address ?
What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address
'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers
what is ip address and what is the difference between the ip address and mac address why we are not using mac address instead of ip address
Which processes does TCP, but not UDP, use? A. Windowing B. Acknowledgements C. Source Port D. Destination Port
The Internet Control Message Protocol occurs at what layer of the seven layer model? A.) Physical B.) Transport C.) Session D.) Datalink E.) Presentation F.) Network
What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count
Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)
CCNA 
