Answer / guest

Answer: D

Answer / 5021

B

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Annex D B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) Anex A

2 Answers  

---

Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP

3 Answers  

---

If there is only 2 host in bus topology is that possible collision accord?

0 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

2 Answers  

---

You create the following standard access-list access-list 1 deny 1.1.1.1 access-list 1 deny 2.2.2.2 int e0 ip access-group 1 in Which of the following statements are true, with regard to traffic flowing into E0? A.) This will stop IP packets with a source address of 1.1.1.1 only. B.) This will stop all IP packets. C.) This is an invalid configuration. D.) This will stop no IP packets. E.) This will stop IP packets with a source address of 2.2.2.2 only. F.) This will stop IP packets with a source address of 1.1.1.1 and 2.2.2.2.

1 Answers  

---

---

Identify the mode reflected by the following prompt 'Router'? A.) Setup B.) RXBoot C.) Boot mode D.) Privileged exec mode

1 Answers  

---

What do you mean by Port Mirroring?

0 Answers  

---

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

2 Answers  

---

Identify 3 characteristics of a connection oriented protocol? A.) Path determination B.) Flow control C.) Acknowledgements D.) Uses hop count as metric E.) 3 way handshake

2 Answers  

---

Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252

1 Answers  

---

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

---

What is a vlan?

0 Answers  

---