Which switching technology can reduce the size of a
broadcast domain?
A.) Cut-Through
B.) Store-and-Forward
C.) Spanning Tree Protocol
D.) RARP
E.) ARP
F.) VLAN
Answers were Sorted based on User's Feedback
Answer / guest
Answer: F
VLAN's are logical ways to break up a large broadcast domain.
To get from VLAN to VLAN you must have a router.
Is This Answer Correct ? | 16 Yes | 2 No |
Answer / vaibhav bhosale
Answer: F
VLAN's are logical ways to break up a large broadcast domain.
To get from VLAN to VLAN you must have a router.
Is This Answer Correct ? | 7 Yes | 0 No |
What is cisco?
You would like to have a notation that when a user issues the command 'show interface serial 0', a line is displayed indicating that, 'This is the connection to Company A.' What interface command would accomplish this? A.) banner motd #This is the connection to Company A.# B.) interface This is the connection to Company A. C.) This cannot be done for an individual interface. D.) description This is the connection to Company A. E.) banner This is the connection to Company A. F.) display This is the connection to Company A.
Explain the difference between tracert and traceroute?
Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#
Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual
Identify the 3 Internet layer IP protocols? A.) NetBios B.) IPX C.) ARP D.) IP E.) RARP
What is osi?
Brielfly explain the conversion steps in data encapsulation
Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port
How do you disable advanced editing? A.) terminal editing B.) terminal no editing C.) disable editing D.) no terminal editing
Which of the following is a valid extended IP access-list? A.) router(config)# access-list 101 permit tcp host 172.16.30.0 any eq 21 log B.) router# access-list 101 permit tcp host 172.16.30.0 any eq 21 log C.) router(config)# access-list 101 permit any any 172.16.30.0 D.) router(config)# access-list 101 permit ip host 172.16.30.0 any eq 21 log
After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1