Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following are solutions to the problems encountered
with Distance-Vector routing?
A.) Defining a Maximum
B.) Poison Reverse
C.) Triggered Updates
D.) Shortest path first algorithm.
E.) Split Horizon
- 1 Answers
- 4998 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A B C E
The Shortest Path First (SPF) algorithm is used only with
Link-State
protocols such as OSPF.
| Is This Answer Correct ? | 2 Yes | 0 No |
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM
Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a
What is a network subnet?
Explain the draw back of ospf protocol?
Which ipsec rule is used for the olympia branch and what does it define?
You are given the IP address of 172.16.2.160 with a subnet mask of 255.255.0.0. What is the network address in binary? A. 10101100 00010000 B. 00000010 10100000 C. 10101100 00000000 D. 11100000 11110000
Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains
What is the minimum and maximum request timer?
What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds
what is distance vector protocol link state protocol and what is the diffrence between them
Mention what BOOTP is?
CCNA 
