Answer / guest

Answer: A

The Session layer controls a conversation between applications.

The Transport layer controls communications between hosts.

What three occurrences will reset the holddown timer after a triggered update? A.) Infinity is finally defined as some max number B.) HD Timer expires C.) Another update is received indicating a better metric D.) The router receives a processing task proportional to the number of links in the internetwork E.) The router detects fault LSP's propagating through the internetwork F.) Another update is received indicating net status changed

1 Answers  

---

What is the difference between static and dynamic ip addressing?

0 Answers  

---

What is matric?

0 Answers  

---

Identify 3 characteristics of a MAC address? A.) Burned into the NIC B.) 48 bits long C.) Length is 32 bits D.) Used to identify a host device E.) Contains a network portion and a host portion

2 Answers  

---

What is the routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) TTL D.) Hop count

1 Answers  

---

Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigining the IP address 192.168.100.0 to an interface

2 Answers  

---

The -- terminal no editing -- command will perform what function? A.) Edit the contents of NVRAM B.) Allows access to the terminal port C.) Stops the advanced editing feature D.) Enable password functions

1 Answers  

---

Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2

1 Answers  

---

Explain what is overlaod?

0 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers  

---

why we twist the cable in case of twisted pair cable?plz give me technical answer.

5 Answers   Infosys, NSN,

---